The smart wear craze is growing. Especially in the bracelet industry, all kinds of brands and styles in the world can be described as blooming. From no display screen at the beginning to monochrome screen later, to the colorful screen now, it is difficult for users to choose between beauty and endurance, Weloop can be said to be a unique representative. The launch of each product can bring about turbulence in the bracelet market. At present, Weloop mainly has two kinds of Now series and Xiaohei series. Now, the second generation of Weloop Now2 has been launched, so what different experience will be brought by Now2 this time.

First of all, from the perspective of packaging, compared with previous generations of products, Weloop Now2 is simple and straightforward. Transparent plastic box plus paper inner box, but simple is not necessarily bad. It is suggested that the official can use the packaging of Xiaohei 2 for reference, which can be divided into ordinary version and gift version. As a gift, it also has more face.

A protective film is pasted on the top of the screen to prevent scratching the screen during transportation. The bracelet is stuck in the middle of the box, and the data cable and charging seat are on the lower layer.

From the screen appearance, Weloop Now2 is very similar to the previous Now CLASSIS, Now2 is equipped with a touchable OLED display, which can call up time, heart rate, push messages and other interactive information by sliding up, down, left and right. It can not only check the messages pushed by the mobile phone at the first time, but also reduce the number of times to take out the mobile phone. The smart bracelet weighs only 16 grams and can hardly feel when worn on the hand.

In terms of accessories, Now2 is only equipped with a charging cable and a charging base, and there is a Reset hole on the back of the charging base. If you need to reset, just snap the base on the watch, and press and hold the needle to restore the factory settings.

Four charging contacts are provided on the back of the bracelet, which can charge the bracelet without taking off the main body. The heart rate sensor is in the middle, which is used to record the user's heart rate. When the detection is turned on, a green light will be emitted. During the measurement, the arm should be kept stable, and the wearer should not be too loose. The current heart rate can be displayed after a few seconds, Users can set a fixed time for measurement through the APP, and click on the bracelet to measure. However, opening the timing measurement will significantly reduce the standby time of the bracelet. If there is no strong demand, I think it is better to close it.

The bracelet and wrist strap are made of TPU material, which is called thermoplastic polyurethane elastic banana in Chinese. It has the characteristics of wear resistance and oil resistance. It is very suitable for making bracelet and wrist strap and other parts that need to be pulled. It will not be easily pulled off. In addition to being resistant to pulling, The softness of the TPU is also very suitable, and it will not cause skin discomfort when wearing. However, the pure black cannot show the personality. We hope that the official can launch a colorful wrist strap for users to choose from.

The charger of the bracelet is very small. Align it with the notch on the bracelet and press it in. The charging port is Micro USB, which can be charged using most of the data lines on the market. If the charging function can be directly integrated into the bracelet, and a charging interface can be left directly inserted, the use experience will be improved to a higher level.

At present, Weloop already supports both Android and Apple platforms. The download and installation process will not be repeated. After opening the APP, select to bind Weloop Now2, which is linked to the mobile phone through Bluetooth 4.0. On the APP home page, the movement of today is visually displayed, and the heart rate, movement and sleep are listed below, The APP automatically lists the average and peak valley values of heart rate. Exercise can be divided into low exercise, walking, running, etc. Sleep can be divided into deep sleep, light sleep, and awake. The calendar in the upper left corner can also be used for users to review historical movement information, and the upper right corner can be switched to weekly and monthly data. All kinds of data are clear and intuitive.

Through the ranking list of APP, you can PK friends who also wear Weloop devices. The personal page shows the integration and analysis of past data, The key point of the APP is the device page, where you can set the message push, schedule reminder, alarm clock, etc. Message push is the main reason why many users choose bracelet products. Now2 not only supports the push of SMS and phone calls, but also supports user-defined selection of any APP for notification push.

The schedule reminder and daily alarm clock are set in a simple way. They can be set when you get started, and they will be prompted by vibration when the time comes. However, the intensity of vibration cannot be set for the time being. When Do Not Disturb mode is enabled, the bracelet will be in silent mode and will not be reminded when receiving messages.

In the basic settings, personalized settings can be made according to the user's usage habits, including left and right hand settings, wrist turning screen, horizontal and vertical screen, etc. There are simple descriptions of the settings below each setting, so that the user will not feel unclear when setting. Therefore, the anti loss function of the mobile phone is turned on, and a prompt will be given when the bracelet Bluetooth is disconnected, The biggest two points of Now2 are the interception settings. In other words, it is the incoming call firewall. At present, it should be the first bracelet with this function. However, it should be noted that this function is based on Sogou AliCloud, and some numbers will be mislabeled. Enabling this function may lead to wrong calls.

In addition to viewing the motion data in the APP, you can also view the steps, calories and kilometers by sliding the screen, which is convenient for users to view at any time. At the same time, Now2 has also achieved the ultimate in waterproofing. The official data is 30m waterproof, which ensures that Now2 can work normally even when swimming and bathing. In terms of standby, Now2 also continues the long standby feature of Xiaohei 2. When all projects are started, there is still one third of the power left after two weeks of standby, which is also a surprise.

Now2 supports the push of calls and messages. When the phone is connected, the bracelet will give a vibration prompt. At this time, you can choose to long press the screen of the bracelet to hang up, or pick up the phone to answer. When receiving a short message, the bracelet will automatically scroll the screen. However, due to the screen lighting time, the short and long messages may not automatically scroll over. Here, we also hope to add the function of manually adjusting the screen lighting time for users to set by themselves.

Open the APP, and the bracelet will automatically upload data to the APP for viewing in the APP.

As an old fan of Weile, my expectations for Now2 are self-evident, and from this experience, I have really lived up to my expectations. With a display screen and message push, I have not only achieved the ultimate in standby, but also increased many functions compared with previous products. The introduction of innovative call firewall has also added a huge highlight to Now2, In addition, Now2 does not lag behind in traditional exercise and sleep detection. The price of 199 is really low in today's bracelet market. If you are still waiting for a bracelet with a display screen, you can try Weloop Now2. I believe you will not regret it.