Love to play computer games On June 19, it was reported that Macotakara, a foreign media, had recently uploaded a video of three new iPhone models. Previously, the CAD design drawings of the new iPhone had been disclosed, and the three models were printed out in 3D according to the design drawings. The frames of the three machine models in the video are relatively thick, especially the 6.1 inch version. Of course, the visual error is caused by the shooting angle. In addition, these three new models all use Lightning interface.

The first to get started was the second generation iPhone X equipped with a 5.8 inch screen. The overall dimensions of the iPhone X were 143.65mm × 72.03mm × 7.69mm, which was 1.1mm wider than the previous generation. Macotakara believed that the width of the body did not change, mainly because the phone buttons became thicker, because it was easy for them to put the protective case of the iPhone X on the new machine.

It was previously reported that the largest iPhone X Plus uses a 6.5 inch screen. However, the screen of the model is 6.4 inches. The size of the model is 157.53mm × 77.44mm × 7.85mm, which is about the same size as the iPhone 8 Plus. The length is about 1mm shorter and the width is about 0.7mm narrower. The new model uses a 19.5:9 ratio screen. Like the new 5.8-inch iPhone, it uses a rear dual camera and built-in TrueDepth sensor to support 3D face recognition.

The screen size of the cheap version of the new iPhone is not 6.1 inches, but 6.0 inches. However, it does use an LCD screen. The body size is 150.91mm × 75.72mm × 8.47mm, which is the thickest of the three new models. This is because it is equipped with an LCD screen. In addition, the rear camera of the machine has only one camera, and the SIM card slot is at the lower right of the middle frame of the machine body.

Follow our Weibo @ Love Computer

Follow our WeChat official account: playphone

Of course, we also pay attention to our Bilibili account: love computer