Yes, the above one is very good and looks cool, but I really want to dismantle it. After a probe, I hold it, hold it, hold it... I don't hold it, so this is the dismantling post.

▲ First remove the anti-skid rubber ring of the base, and then three screw holes will be seen, and then remove

▲ If you remove the base plate, you will find that there is an internal backplane, which is mainly used to connect the two internal motherboards

Fix it and support the installation of the base. Its disassembly method is to pry, which can be seen from the figure above

When there are five rectangular holes, that is where the buckle is.

▲ Pry off the internal backplane and we can see the circuit board. There are two circuit boards in total,

The lower part of each piece is fixed by two screws, and it needs to be disassembled with a long rod screwdriver.

▲ Remove the mainboard

▲ Look inside the shell. There are four screw columns inside, which respectively fix two mainboards.

▲ Disassembled

▲ Another front view

▲ Dismantle the external connecting shells of the two mainboards, and basically all of them have been disassembled. As for re disassembly

Then I won't be able to install it.

▲ Mainboard power supply is connected by four wires between boards, and data transmission is completed by an ultra short dual male USB3.0 cable.

▲ Take a look at the front disassembly drawing

▲ Seven USB sockets are arranged in sequence, and the five blue USB sockets above are USB 3.0 data sockets,

The two yellow ones below are USB charging ports.

▲ Backplane

▲ Back of front panel

▲ The data transmission of the two mainboards depends on this USB 3.0 data cable

▲ Wire is fixed to the mainboard by hot melt adhesive.

▲ The mainboard is relatively smooth and the hot melt adhesive is easy to come down, so it is easy to disassemble.

▲ Take a look at the base inlaid with the front and rear panels. The mold is really good.

▲ Especially the front is basically flawless.

▲ Similarly, the workmanship of the base is commendable.

▲ Take a look at the internal screws. There are 12 internal screws. Each circuit board needs 4 screws to be fixed to the panel,

Each motherboard needs 2 to be fixed to the HUB body.

▲ The other three screws are used to fix the base. The quality of the screws is good. They are disassembled for two or three times, and the screws are free of flower.

▲ After assembly, the test is normal. After this disassembly, I hope you enjoy it.

---===over===---