At the beginning of the New Year, when the whole country celebrated the holiday, Xiao Bian was also immersed in the festive atmosphere. But It was at this time that an unfortunate thing happened - the iPhone 5s on hand became a special effect of its own snowflake wallpaper, as shown in the following figure. I believe everyone can feel my mood at this moment.

In order to have a happy and peaceful Spring Festival, I went to Huaqiangbei alone and managed to buy a 5s screen assembly, starting today's "cosmetic journey". The kind-hearted shopkeeper gave me some dismantling tools for my poor sake. Of course, it would be better if I had tools. You need a small screwdriver, a hexagonal screwdriver, a crowbar and a suction cup for removing the iPhone.

Hard to buy screen

Disassembly tool

First, use a hexagonal screwdriver to remove the two screws near the iPhone speaker. Since the screen is broken, you can't directly pull up the screen with a suction cup like a new phone. At this point, finally stick a layer of transparent tape or film on the phone, so that the suction cup has a smooth surface to suck up the screen. Because it was so broken, I had to use a sucker to suck it again and pry the gap between the screen and the body with a crowbar. It was not easy to pry up the screen. At this time, be careful. There is a flat cable connected to the motherboard near the 5s HOME button. Be careful not to break the flat cable when opening the screen. After gently touching the ribbon cable of the HOME button, be careful when opening the screen to the earpiece. The ribbon cable of the display screen is nearby. There are 4 screws on the main board. After removal, the three flat cables connecting the display screen and the main board can be removed by uncovering the iron plate.

Extremely difficult process

Remember to remove the HOME cable

Flat cable of screen and mainboard

Remove the later screen

After the hard removal, we should pay attention to that, because no iPhone's fingerprint identification is one-to-one with the motherboard chip, and cannot be replaced, the original HOME button must be removed from the old phone, and then installed on the new screen. There are three screws on the HOME button, and you need to be careful when removing glue.

Remove the HOME button

Dismantled appearance

Change the HOME button to the new screen

Then install the flat cable of the new display screen onto the main board in the reverse order above, and then install the four screws on the small iron plate. Be sure to connect the flat cable of the HOME button before plugging the display. Since it is difficult to install the flat cable of HOME at this angle, you must be patient at this time.

Reinstall the screen

Connect the HOME cable

After installation, do not press the screen tightly. Start the machine to see if the touch screen can be used. If you can't use it, check whether there is an installation error first. If not, find a profiteer to replace the screen and try again.

Test whether touch is available

After everything is right, we can have a happy New Year! Wish everyone a happy New Year in advance