The Weibo user @ Ruiji, who was the first to expose iPhone 6, disassembled the new phone and revealed the changes in the internal design of iPhone 6 for the first time by comparing it with the iPhone 5s.

Rear panel disassembly drawing ▲

Disassemble and compare iPhone 5s

The disassembly method of iPhone 6 and iPhone 5s is roughly the same, but the display screen removed from iPhone 6 is slightly thicker than that of iPhone 5s. The cable arrangement responsible for transmitting the display screen, earpiece, front camera, and TouchID fingerprint identification information is all changed to the top of the screen.

Back view of front panel ▲

From the layout of the main board of the iPhone 6 compared with the iPhone 5s, the general wiring structure of the iPhone 5s is not much different from that of the past. However, since the screen lock key is placed on the right side of the body, there are some minor changes in the wiring, and the battery capacity is increased to 1810 mAh. Overall, the internal structure of iPhone 6 and iPhone 5s is very similar.

It is difficult to disassemble, and the sapphire lens is not afraid of wear

However, the disassembly of the iPhone 6 is more difficult than that of the iPhone 5s, while the motherboard is still a double-layer design, and the storage module is provided by Toshiba. Since the iPhone 6 supports five modes and more than 10 frequency bands, the area of the wireless module increases while the enclosure antenna edge is thickened. This means that Bluetooth Wi-Fi、 Radio frequency and other functions will have better performance.

Main board comparison diagram 1 ▲

Main board comparison diagram 2 ▲

As for the convex wear of the camera that everyone is very concerned about, the results of this disassembly show that the exterior of the iPhone 6 camera is sapphire glass, and the metal ring cutting also has a certain angle, so the disassembler believes that there is no need to worry about wear. In addition, the iPhone 6 is also equipped with oversized speakers. In the environmental test of about 43 decibels, the same built-in ringing tone is used to adjust to the maximum. The iPhone 5s can reach about 100 decibels, while the iPhone 6 can reach 108 decibels.

Speaker unit diagram ▲

Exposure of components made in Japan

It is worth mentioning that the Japanese media also published articles detailing the Japanese made components used in the iPhone 6. First of all, the suppliers of the "actuator for optical anti shake correction" carried by the iPhone 6 Plus camera are considered to be Japan Alps Electric and Sanmei Electric, and it is said that the price of this new actuator is 50% to 1 times higher than the previous product, so it is only used for some advanced models.

Camera module comparison diagram ▲

As for the layered CMOS image sensor used by the camera of iPhone 6, Sony and others supply it, while the touch screen of iPhone 6 is provided by Japan Display, including 4.7 inch and 5.5 inch LCD panels. In addition, the "LED backlight", which is placed inside the display screen and plays the role of adjusting the brightness of the image, will also be supplied by Meibei, a Japanese company. The high frequency components used in the signal transmission lines of the LTE network will use the filter products of Murata Manufacturing Institute in Japan.

Vibrator unit diagram ▲

Via： Tencent Digital