On August 19th, we Love to play computer games We also received an invitation from Meizu MX3 press conference. The design of the invitation letter is very unique, and there is also a MX3 woodcut model engraved by J. Wong. That is to say, the general appearance design of MX3 will come to the surface, no longer mysterious. Now let's take a look at the appearance of the new Meizu flagship.

The invitation letter for this press conference is a small box with only one big MX3 on it.

There is only Meizu's information and a security label on the back.

The label has a laser anti-counterfeiting label, on which is the venue of the conference - Water Cube.

Open the box.

There is a text invitation inside.

There is also a story about this hand ground MX3 woodcut model, you can have a look.

Then the inside is a replica of the MX3 wooden model that was milled by J. Wong himself.

MX3 is designed as a 5-inch screen. It can be seen from this that MX3 still adheres to the narrow frame design. The interface of this wooden model is a SMS interface, with Flyme's virtual key design below.

The design on the top of the machine is the central earpiece. Next to it are two sensors, and the front camera is on the right.

Home key at the bottom.

A NFC sticker was specially pasted on the back design. It seems that NFC is indispensable.

We tried to read the NFC sticker on the back, and found that it could be read, but there was no content in it. It seems that it is the NFC sticker that will be used in future press conferences.

The main camera on the back, below is an LED fill light. We noticed that there is a dot in the center of the camera and fill light, which should be the noise reducing microphone. In addition, there is a 3.5mm headphone plug on the upper right, which still seems to be placed on the slope.

There is an engraved yellow seal signature at the bottom, and then there is a speaker at the bottom. The speaker is in this position... It's OK to hold the phone with your right hand, but it will completely cover the speaker with your left hand.

In terms of the grip of the wooden model, it feels good. The round corners will not cause too much pressure on the palm.

And the back is sleek.

From the front and side, the radians of the MX3 are different from top to bottom. The left is the head of the phone,

The right is the tail. In addition, the design of the power key and volume key has not been depicted, which may be because the design has not been determined, or we want to give us some special surprise design.

Of course, this is only a wooden model, which is still hand polished. The data details of the model may not be very fine, but only for appearance reference. As for the complete MX3 appearance, it can only be seen at the press conference on September 2.