During installation, CPU、 The three major components of motherboard and graphics card can be easily determined. The choice of chassis, heat sink and power supply is also complicated due to many brands and various technical parameters. Among them, the power supply is fairly good, just calculate the overall load and various gold medals. The V series is the new power supply series launched by Cooler Master. Compared with the previous conventional design, the packaging design of the V series is more high-end, grand and overall more high-end. The V series is also divided into two small series according to the full module and half module. The V750s this time belongs to the half module. The 80PLUSjinpai in the upper right corner is also the expression and demonstration of the quality of workmanship and conversion efficiency. Of course, the V series is the 80PLUS gold medal.

On the back is a list of accessories and curve efficiency.

The power supply design is simple and clean, the surface is dark black, and the low-end appears high-end. The logo of the V750 and the Cooler Master are on both sides of the power supply, which is quite obvious. (Although it can't be seen once it is covered.)

The power supply nameplate has various relevant information. The input voltage of V750 is 100~240V, which reaches the broadband input. In short, even when the voltage is unstable, the current output can be stable to ensure normal operation. The V750 uses a single 12V output, and the output current reaches 62A, which is basically pressure free.

The fan is a common honeycomb mesh design. It uses a double ball bearing inner core, which has a long service life and a fast rotating speed. However, the manufacturing cost is high, and the noise effect is unacceptable.

The V750 uses a half module design, and the power cable interfaces are rich. It has designed one motherboard interface (20+4 PIN), one CPU power supply interface (4+4 PIN), four graphics card interfaces (6+2Pin), eight hard disk interfaces (SATA), one floppy drive interface (small 4pin), and six power supply interfaces (large 4pin).

The module wire is flat design, with moderate length, which is much more convenient for routing. The V750 provides a total of 8 SATA power interfaces, 6 large 4pin D-type interfaces and 2 small 4pin interfaces. The module interface adopts 5P design, and the customized line for playing is also appropriate.

The front of the power supply is a commonly used honeycomb network design, a power input interface and an independent power switch key.

Active PFC+DC-DC interface is used inside the power supply. The active PFC is a common and mature design in high-power power supply at present, and the DC-DC structure also provides a good foundation for the conversion efficiency of V750. There are two EMI circuits in the V750 power supply, which are designed in AC power and integrated in the input socket. The whole EMI filter design is quite good.

The capacitors of the V750 are high-quality Japanese capacitors, and there are quite a lot of solid capacitors, which enhance the stability of the power supply. In addition, there are multiple protection designs such as overvoltage, low voltage and short circuit, which can well meet the requirements of players.

The rated power of the Cooler Master V750s is 750W, which can well meet the power supply conditions and requirements of hardware enthusiasts in the case of dual card SLI, and is also a luxury configuration in terms of internal materials. Of course, in terms of more important conversion efficiency, the V750 also performs very well, and the 80PLUS gold medal guarantee is also appropriate.